Step | | Procedure & Parts & Tools |
1 |
|
Disconnect the Main Negative Battery lead.
Wrench-9/16 in |
|
|
2 |
|
Remove 2 screws at the rear panel.
Screwdriver-phillips |
|
|
3 |
|
Locate the bundle of wires up at the top of the control panel. You may need to disconnect them now before removing the switch. Note wire positions.
|
4 |
|
Using a Flathead screwdriver to pry under, squeeze the tabs on each side of the switch for it to start to lift.
Screwdriver-flat tip |
|
|
5 |
|
Once one side if free, pry the other till it comes completely up. Pull switch out from control panel.
Reverse Steps to reinstall new switch. Connecting wires in the same locations.
|