USAfixTM - Repair Guide (RG) - Master Email RG
- Test Ignition Module
 Level of Difficulty - HIGH  Estimated Completion Time - 15 minutes
MINUTE - M-220028K17

Tools Required
Tool 
Screwdriver-flat tip
Spark tester

Parts Required


Step Procedure & Parts & Tools
1 LOCATE SPARK PLUG WIRE

2 PULL TO DISCONNECT SPARK PLUG WIRE

3 IF YOU DO NOT HAVE A SPARK TESTER, INSERT FLAT TIP SCREWDRIVER IN THE END OF PLUG WIRE
Screwdriver-flat tip

4 GROUND BY LAYING SCREWDRIVER AGAINST THE ENGINE (DO NOT TOUCH METAL WITH YOUR HAND AS YOU WILL GET SHOCKED)
Screwdriver-flat tip

5 IF THERE IS A SPARK, THE SPARK PLUG WIRE IS GOOD, NO SPARK, REPLACE THE SPARK PLUG WIRE
Screwdriver-flat tip

6 INSERT THE METAL END OF SPARK PLUG TESTER INTO SPARK PLUG WIRE. CONNECT THE RUBBER END OF THE SPARK PLUG TESTER ONTO THE SPARK PLUG
Spark tester

7 CHECK SPARK PLUG TESTER FOR A SPARK, IF THERE IS A SPARK, THE SPARK PLUG WIRE IS GOOD, NO SPARK, REPLACE THE SPARK PLUG WIRE
Spark tester

8 TEST BOTH SPARK PLUG WIRES