Step | | Procedure & Parts & Tools |
1 |
|
Open Tank Lid
|
2 |
|
Using T-30 Torx, Loosen 2 screws on rubber buffers. Complete removal of screws is not needed.
Torx T30 |
|
|
3 |
|
Once rubber buffers of loose, separate the lower plate from tank lid
|
4 |
|
On terminal block, locate Red and Black pump wires. Loosen set screws with small flathead screwdriver and remove wires from block.
Screwdriver-flat tip |
|
|
5 |
|
Open tank again, and loosen the gray strain relief with a 17 mm wrench.
Wrench-metric 17mm |
|
|
6 |
|
Once strain relief cap is loose, pull the pump wires through.
|
7 |
|
With cutters, free the pump wires by cutting the zip-ties down the solution hose.
Wire cutters |
|
|
8 |
|
With Flathead, loose hose clamp by the pump and remove from hose. Reverse steps to install new pump.
Screwdriver-flat tip |
|
|