Step | | Procedure & Parts & Tools |
1 |
|
Lift the recovery tank from the machine and carry to drain to empty. Push the machine over a drain and remove the yellow solution filter cap to drain solution tank.
|
2 |
|
Raise the tank cover up until it pops off machine.
|
3 |
|
Locate the 2 hoses coming up through the solution tank. Pull the 2 hose cuffs off hoses.
|
4 |
|
Using a socket wrench, remove the 3 bolts holding the handle.
Torx T30 |
|
Ratchet-Socket metric 10mm |
|
|
5 |
|
Using an Allen wrench, remove the 3 bolts holding the handle cover.
Wrench-Allen metric 4.0mm |
|
|
6 |
|
Pull the handle cover from the machine.
|
7 |
|
Slide the handle off the gear.
|
8 |
|
Using a socket wrench, remove the 4 bolts holding the back cover.
Torx T30 |
|
Ratchet-Socket metric 10mm |
|
|
9 |
|
Using a socket wrench, remove the 2 bolts in the electrical compartment.
Torx T30 |
|
Ratchet-Socket metric 10mm |
|
|
10 |
|
Using a socket wrench, loosen the bolt on the front of the solution tank.
Torx T30 |
|
|
11 |
|
Using a socket wrench, remove the 2 solution tank bolts on each side of the tank.
Torx T30 |
|
|
12 |
|
Using a Phillips screwdriver, remove the bottom screw underneath the machine.
Screwdriver-phillips |
|
|
13 |
|
Pull out white connector block and use a flat head screwdriver to loosen the 2 screws holding the black wires. Pull to remove the black wires from the block.
Screwdriver-flat tip |
|
|
14 |
|
Set the machine right side up and lift the solution tank from the machine.
|
15 |
|
Pull the vac motor cover with attached hose to remove it from the machine.
|
16 |
|
Lift the vac motor from the machine. Reverse steps 1-18 to install a new vac motor.
|