USAfixTM - Repair Guide (RG) - Master Email RG
- Check and/or replace capacitor wiring
 Level of Difficulty - Medium  Estimated Completion Time - 15 minutes
TASKI - ERGODISC 200

Tools Required
Tool 
Screwdriver-phillips
Wire cutters

Parts Required
PartDescriptionPriceAvailablePurchase
192-2355 Bumper ring $16.19 Back Order Qty:


Step Procedure & Parts & Tools
1 TURN KNOB TO REMOVE WEIGHT.

2 REMOVE 2 SCREWS HOLDING BOTTLE HOLDER.
Screwdriver-phillips

3 REMOVE 6 SCREWS (3 ON EACH SIDE)FROM COVER.
Screwdriver-phillips

4 PULL COVER OFF MACHINE.

5 SET BUMPER PROFILE ASIDE. REPLACE IF DAMAGED. (SOLD BY INCH)

PartDescriptionPriceQty
192-2355 Bumper ring $16.19 Qty:  
6 REMOVE 2 SCREWS HOLDING CAPACITOR BRACKET.
Screwdriver-phillips

7 LIFT THE CAPACITORS BRACKET OUT OF MACHINE AND INSPECT WIRING.

8 IF WIRING IS BAD, CUT OFF BAD SECTION OF WIRING, IF WIRE IS STILL LONG ENOUGH TO REACH THE WIRE CONNECTOR, STRIP WIRE ENDS A 1/4 IN AND REINSTALL TO WIRE CONNECTOR. IF WIRING IS TOO SHORT, SPLICE IN AN ADDITIONAL LENGTH, USE AN APPROVED CONNECTOR SUCH AS A WIRE NUT AND TAPE, THEN CONNECT TO WIRE CONNECTOR.
Wire cutters