USAfixTM - Repair Guide (RG) - Master Email RG
- Check for power to the relay and capacitors
 Level of Difficulty - HIGH  Estimated Completion Time - 15 minutes
TASKI - ERGODISC 200

Tools Required
Tool 
Screwdriver-phillips
Volt meter (True RMS capable)

Parts Required
PartDescriptionPriceAvailablePurchase
192-2355 Bumper ring $16.19 Back Order Qty:


Step Procedure & Parts & Tools
1 TURN KNOB TO REMOVE WEIGHT.

2 REMOVE 2 SCREWS HOLDING BOTTLE HOLDER.
Screwdriver-phillips

3 REMOVE 6 SCREWS (3 ON EACH SIDE)FROM COVER.
Screwdriver-phillips

4 PULL COVER OFF MACHINE.

5 SET BUMPER PROFILE ASIDE. REPLACE IF DAMAGED. (SOLD BY INCH)

PartDescriptionPriceQty
192-2355 Bumper ring $16.19 Qty:  
6 THERE ARE 2 QUICK CONNECT BLOCKS COMING FROM THE INSIDE BACK WALL OF THE WIRE COMPARTMENT. LOCATE THE BLOCK WITH THE RED, ORANGE AND GREEN WIRES.

7 DISCONNECT THE BLOCK WITH THE RED, ORANGE AND GREEN WIRES. USING THE FEMALE END, INSERT THE BLACK LEAD INTO THE GREEN WIRE SLOT AS SHOWN. INSERT THE RED LEAD INTO THE ORANGE WIRE SLOT AS SHOWN. NOTE: YOU WILL NOT USE THE SLOT WITH THE RED WIRE. PLUG IN MACHINE AND USE LEVER TO ACTIVATE THE MACHINE. SET THE VOLT METER TO AC VOLTAGE. THE VOLT METER SHOULD READ APPROX. 120 VOLTS.
Volt meter (True RMS capable)